Integrated Control Panel

REMOVAL







1. Disconnect the battery ground cable.







2. Remove the screws and the console glove compartment door and hinge assembly.







3. Disconnect the console rear panel.
1 Remove the screws.
2 Disengage the clips.







4. Remove the rear integrated control panel.
1 If equipped, disconnect the floor/panel control cable at the control head.
2 Disconnect the power point electrical connector.
3 If equipped, disconnect the blower motor control electrical connector.
4 Disconnect the radio control electrical connector.
5 Remove five screws.

INSTALLATION
1. To install. reverse the removal procedure.

NOTE: When the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the vehicle relearns its adaptive strategy. The vehicle may need to be driven 16 km (10 mi) or more to relearn the strategy.