RH Rear Cable and Conduit

REMOVAL





1. Relieve the tension on the parking brake system.
1 Pull the front parking brake cable and conduit.
2 Insert a suitable retainer.

NOTE: Make sure the parking brake control is fully released.

2. Raise and support the vehicle.

WARNING: THE ELECTRICAL POWER TO THE AIR SUSPENSION SYSTEM MUST BE SHUT OFF PRIOR TO HOISTING, JACKING OR TOWING AN AIR SUSPENSION VEHICLE. THIS CAN BE ACCOMPLISHED BY TURNING OFF THE AIR SUSPENSION SWITCH LOCATED IN THE RH KICK PANEL AREA. FAILURE TO DO SO CAN RESULT IN UNEXPECTED INFLATION OR DEFLATION OF THE AIR SPRINGS, WHICH CAN RESULT IN SHIFTING OF THE VEHICLE DURING THESE OPERATIONS.





3. Disconnect the front parking brake cable and conduit from the RH parking brake rear cable and conduit.





4. Compress the parking brake cable clip. Remove the RH parking brake rear cable and conduit from the parking brake cable equalizer.





5. Remove the screw.





6. Compress the retainer and release the parking brake rear cable and conduit from the rear disc brake caliper anchor plate.





7. Unclip the parking brake rear cable and conduit from the parking brake lever.





8. Remove the pushpin located in the crossmember and the RH parking brake rear cable and conduit.

INSTALLATION





1. Follow the removal procedure in reverse order.