Shoulder Safety Belt Height Adjuster With Stripped Weld Nuts

D-Ring Installation Kit:

Special Tool(s)

1. Remove the upper and lower corner trim panels.





2. Use the half-inch drill provided in D-Ring Installation Kit 100-F012 (134-00018) or equivalent to drill out the damaged threads in the upper B-pillar structure.
3. Apply a suitable lubricant to the M14x1.5 tap provided in D-Ring Installation Kit 100-F012 (134-00018) and tap new threads.

NOTE: After each rotation, back tap off slightly to remove new cuttings and be sure to clean out any chips before proceeding.





4. Use a threaded insert (N807170-5190) provided in D-Ring Installation Kit 100-F012 (134-00018) or equivalent and screw it into the retapped hole until it is slightly below the surface of the hole.





5. Use a hammer to lightly tap the installation tool provided in D-Ring Installation Kit 100-F0 12 (134-00018) several times to drive down the insert keys.

NOTE: If the two hex-head bolts on the front seat shoulder strap adjuster are not stripped, refer to Height Adjuster Shoulder Safety Belt to install the height adjuster to the body. If the front seat shoulder strap adjuster bolts are stripped, replace the adjuster. Removal and Installation