Initial Inspection and Diagnostic Overview

INSPECTION AND VERIFICATION

Leaks

NOTE: The trim will reveal the location of most leaks. Use spray chalk and a hose, if necessary.

1. Remove any trim or carpet in the general area of the leak.
2. Road test or water hose test the vehicle.
3. Inspect for a dust pattern around the area in question. Inspect for water paths near and above the area in question.
4. Some leaks can be located by placing bright light under the vehicle, removing trim or carpet as necessary and inspecting the interior of the body at joints and weld lines.

Noise
Wind noise, rattles and their sources are detected by driving the vehicle at highway speeds. Drive the vehicle in four different directions, with all windows closed, radio off, blower motor off and all ventilation ducts open.

Most wind noise leaks will occur at the door and window seals or at the sheet metal joints in the door or the door opening.