Ignition Switch Replacement

Removal and Installation
1. Disconnect the battery ground cable.





2. CAUTION: Use care when removing the instrument panel steering column cover or damage to the cover locating tab may occur.

Remove the instrument panel steering column cover.
1 Unlock the retainers.
2 Remove the instrument panel steering column cover.





3. If equipped, remove the tilt wheel handle.





4. Remove the lower steering column shroud.
1 Remove the screws.
2 Remove the lower steering column shroud.





5. Disconnect the ignition switch electrical connector.
1 Remove the electrical connector bolt.
2 Disconnect the electrical connector.





6. Remove the ignition switch.
1 Remove the screws.
2 Remove the ignition switch.

7. To install, reverse the removal procedure.