Rear Door Non-Functional - Latch Replacement

REMOVAL

1. Remove rear-seat lower cushion(s).

All vehicles:

2. Remove door trim panel. For additional information refer to section 501-05: Interior Trim and Ornamentation "Rear Door Trim Panel Removal and Installation."

3. Position aside water shield.

NOTE
IF LEVER WILL NOT MOVE FREELY, CYCLE THE DOOR LOCK BUTTON AND HANDLE TO FREE LEVER.

NOTE
USING A SMALL SCREWDRIVER, INSERT SCREWDRIVER INTO LATCH ASSEMBLY AT OUTSIDE BASE OF ELECTRICAL CONNECTOR BELOW METAL ACTUATING LEVER AND PRY UP (FIGURE 2, PASSENGER FRONT DOOR SHOWN, ALL DOORS SIMILAR).

4. Remove latch. For additional information refer to section 501-14: Handles, Latches and Entry Systems Rear Door Latch Removal and Installation".

INSTALLATION

1. Install new latch. For additional information refer to section 501-14: Handles, Locks, Latches and Entry Systems "Rear Door Latch Removal and Installation."

2. Install door trim panel. For additional information refer to section 501-05: Interior Trim and Ornamentation "Rear Door Trim Panel Removal and Installation."

3. Install rear-seat lower cushion(s).