Brake Fluid Reservoir

Brake Fluid Reservoir

Removal

WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If brake fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally, drink water and induce vomiting. Get medical attention immediately. Failure to follow these instructions may result in personal inquiry.

CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with water.





1. Disconnect the fluid level electrical connector.
2. Using a suitable suction device, drain the brake master cylinder reservoir.





3. If equipped with manual transmission, disconnect the clutch master cylinder feed.





4. Remove the brake master cylinder reservoir.

Installation

NOTE: Whenever installing a new brake master cylinder reservoir, install new seals.





1. Install the new brake master cylinder reservoir.
1 Lubricate the two seals with clean brake fluid and insert the seals into the brake master cylinder.
2 Press the brake master cylinder reservoir into the seals until it snaps in securely.
3 Connect the brake master cylinder fluid level warning switch electrical connector.





2. If equipped with manual transmission, connect the clutch master cylinder feed.
^ Bleed the clutch master cylinder.
3. Bleed the master cylinder.