Outlet

REMOVAL







1. Loosen the clamp and separate the air cleaner outlet tube and resonator from the Air Cleaner (ACL).







2. Disconnect the Mass Air Flow sensor (MAF) connector from the engine control sensor extension wiring and release the air cleaner clamp.







3. Remove the outlet side of the air cleaner.
4. Remove the mass air Flow (MAF) sensor from the outlet side of the air cleaner.

INSTALLATION

1. To install, reverse the removal procedure.

CAUTION: The grommet used to seal the air cleaner housing at the extension must be fully seated. Failure to do so will result in unmetered air entering the engine.

NOTE: Use the alignment notch to properly align the inlet side and outlet side of the air cleaner.