Safety Belt Shoulder Height Adjuster With Stripped Weld Nuts

D-Ring Installation Kit:

SPECIAL TOOL(S)

1. Remove the B-pillar trim panel.







2. Use the half-inch drill with integral stop provided in D-Ring Installation Kit to drill out the damaged threads in the upper pillar structure.







3. Apply a suitable lubricant to the M14 x 1.5 tap with integral stop provided in D-Ring Installation Kit and tap new threads.

NOTE: After each rotation, back off tap slightly to remove new cuttings and be sure to blow out any chips before proceeding.







4. Use a threaded insert (N807170-S190) provided in the D-Ring Installation Kit and screw it into the retapped bole until it is slightly below the surface.






5. Use a hammer to lightly tap the installation tool provided in the D-Ring Installation Kit several times to seat the insert keys.

NOTE: If the two bolts on the height adjuster are not stripped, install the height adjuster.