Rear Case Bushings

Rear Case Bushings





Special Tool(s)

Disassembly

1. NOTE: Remove any minor nicks or burrs using a fine oil stone. Remove the case bushings only if they show signs of excessive wear or scoring.

Inspect the case bushing bores for nicks or burrs.





2. CAUTION: Be careful not to damage the case bore while removing the bushing.

NOTE: Always install both bushings when either bushing is installed. However, remove and install only one bushing at a time. Use the other bushing in the case to help align the tool and the new bushing during installation.

Using the special tools, remove the rear case bushing.

Assembly





1. NOTE: The rear case bushing has one lube groove. The front case bushing has three lube grooves.

Assemble the special tools.





2. Place the assembled special tools through the case and into the front case bushing.





3. CAUTION: Make sure the bushing and tool are centered in the bore.

Install the rear case bushing.
1. Install the rear case bushing over the special tool into the case.
2. Install the special tool.
3. Install the washer and the nut hand-tight.





4. Hold the special tool while turning the nut until the rear case bushing is fully seated. Remove the tools.