5.4L Excursion (4R100)
TYPICAL DIAGNOSTIC REFERENCE VALUESTypical Diagnostic Reference Values, Part 1:
Typical Diagnostic Reference Values, Part 2:
Typical Diagnostic Reference Values, Part 3:
Typical Diagnostic Reference Values, Part 4:
NOTES:
The footnotes are referenced throughout the Typical Diagnostic Reference Value Charts. A letter in parentheses next to a value indicates supplemental information is applicable.
An attempt is made to provide as much information as possible; some vehicles may not display all input and output signals.
The Typical Diagnostic Reference Value Charts do not display fault PIDs. These are PIDs which indicate a hard fault with the circuit. They display a value of "YES" or "NO" and are PIDs ending with an "F".
Reference values may vary +/-20% depending on operating conditions and other factors. RPM values are axle and tire dependent.
For downstream O2S (12, 22) greater activity will result when catalyst monitor is active.
Refer to Introduction, Acronyms and Definitions for technical terms applicable to Ford Motor Company products.
Refer to Diagnostic Methods, Parameter Identification, for PID descriptions. Parameter Identification (PID)
For detailed Transmission diagnostics refer to appropriate Vehicle System. Transmission signals may be referred to in either alpha/numeric form "example" 1=A, 2=B, 3=C.
gs-green state
fs-federal state
A. A/C on.
B. Cooling fan on (single, low or high speed).
C. O2S(s) should switch from rich to lean at least once every 3 seconds. O2S voltage should toggle above and below 0.450 DCV and never be a negative value. Valid O2S switching only occurs during closed loop fuel control.
D. Downstream O2S(s) will stay close to a constant voltage when the catalyst monitor is off (positive value only). When the catalyst monitor is on, O2S will switch rich to lean above and below 0.450 DCV and never be a negative value.
E. Brake pedal applied.
F. EVMV commanded current will vary from 0 mA - 1000 mA depending on PCM command to purge the EVAP system.
G. While pressing transmission control switch (TCS) or switching to manual drive mode.
H. Value is dependent on fuel tank level. Typical operating range is: 15%(Empty) to 90%(Full).
I. Steering wheel turned.
J. Clutch pedal applied.
K. Value is dependent upon ambient air temperature and may fall outside of range.
L. Value is not useful under this condition.
M. If equipped.
N. Transmission in selected range.
O. Values recorded using 100% unleaded gasoline.
P. May change state under this condition.
Q. While pressing switch.
R. Frequency cycles high within a few seconds of turning headlamps on. Frequency cycles back to 0 Hz shortly after cycling high.
S. Canister Vent duty cycles to 100% (close) when EVAP monitor test is running.
T. Refer to Antitheft and Alarm Systems.
U. ECT hardware with CHT logic. Refer to Pinpoint Test DL note,"MARAUDER ONLY". Tests DL: Cylinder Head Temperature (CHT) Sensor
V. EGR voltage and duty cycle will vary from 0-VBAT or 0-100% depending on EGR demand.
W. RPM dependent. If signal is 0 Hz at idle, check signal at 900 rpm.