Operation CHARM: Car repair manuals for everyone.

Tests EM: Emission Compliance



PINPOINT TEST EM: EMISSION COMPLIANCE

WARNING: Crown Victoria Police Interceptor vehicles equipped with fire suppression system, refer to Important Safety Warnings. Failure to follow these instructions may result in personal injury.

Note: Canada and some states or metropolitan areas in the United States require periodic emission or IIM tests. All Ford products are designed to pass these tests. If a Ford product fails an IIM test it is probably because 1) the engine or catalyst temperature was not warm and stabilized before the test or 2) the vehicle had idled excessively before the test.

If any new emission components are installed carry out the following steps before repeating the I/M test procedure:

^ Reset the keep alive memory ( KAM). Refer to Resetting The Keep Alive Memory (KAM).
^ To relearn some basic adaptive learning (trim) values run the engine at 2,5OO RPM for 1 minute and idle the engine for 2 minutes.

Exhaust Gas Analysis Chart

Reference:






Verifying an Excessive Grams Per Mile (GPM) Indication Using a Parts Per Million (PPM) Reading. For vehicle gas reading(s) that are excessive compare the actual GPM reading to the gas cutpoint level needed to pass testing. This gives an indication of how much the PPM reading has to be reduced (if the actual reading is twice the cutpoint the baseline reading has to be cut in half or more).

Example:

^ The actual HC produced by a vehicle is 1.6 gpm. The cutpoint for HC in this example is 0.8 gpm. The actual reading is twice the cutpoint.
^ The HC reading obtained for the same vehicle during the baseline drive averages 440 ppm. In order for this vehicle to pass the IIM test the HC reading from the verification trip must be at least half of the baseline reading or an average of 220 ppm or less.
^ This method only gives a general idea of how much the PPM reading needs to be reduced in order for the vehicle to pass an IIM test that calculates GPM. This test is not exact. Experience still has to be used to determine if the emission readings are reduced enough for the vehicle to pass the IIM test.

EM1 - EM3:





EM4 - EM5:





EM6 - EM9:





EM10 - EM12:





EM13 - EM15:





EM16 - EM18:





EM19 - EM21:





EM22 - EM24:





EM25:





EM26:





EM27: