Antenna Cable: Service and Repair
ANTENNA LEAD-IN CABLERemoval
1. Remove the antenna base.
2. Position the RH front fender splash shield away from the bulkhead.
1 Remove the 2 nuts.
2 Remove the screws.
3 Remove the pin-type retainers.
4 Position the RH front fender splash shield away from the bulkhead.
3. Remove the pin-type retainer and the lower RH A-pillar trim panel.
4. Separate the antenna lead-in cable grommet from the bulkhead and pull the excess cable into the passenger compartment.
5. Remove the audio unit.
6. NOTE: This vehicle uses an antenna lead-in cable that is attached to the instrument panel reinforcement and the defroster air duct. Do not remove the original antenna lead-in cable from the vehicle.
Cut and remove the original antenna lead-in cable connectors and excess cable. Secure the remaining cable ends to avoid rattles or identification problems.
Installation
1. Route the new antenna lead-in cable into the passenger compartment.
- Make sure the grommet is fully seated.
2. Route and secure the new antenna lead-in cable to the instrument panel reinforcement.
3. Install the audio unit.
4. Install the pin-type retainer and the lower RH A-pillar trim panel.
5. Route the antenna cable through the antenna base opening on the cowl.
6. Position the RH front fender splash shield to the bulkhead.
1 Install the 2 nuts.
2 Install the screws.
3 Install the pin-type retainers.
7. Install the antenna base.