Solenoid Body Assembly
Solenoid Body AssemblySpecial Tool(s):
Material:
Removal
1. Remove the transmission fluid pan, gasket and filter.
2. Disconnect the solenoid body electrical connector.
3. NOTE: While lowering the solenoid body, the manual valve may fall out of the solenoid body.
Remove the solenoid body.
1 Disconnect the transmission range (TR) sensor electrical connector.
2 Remove the solenoid body bolts.
3 Remove the solenoid body.
4. Remove the solenoid body gasket.
Installation
1. Install a new solenoid body gasket.
2. Using the special tools, install the solenoid body and loosely install the bolts.
^ While installing the solenoid body, align the manual valve.
3. Tighten all the bolts in the sequence shown.
^ Tighten to 13 Nm (10 ft. lbs.).
4. Connect the TR sensor connector.
5. Install the transmission fluid filter, pan gasket and pan.
6. Connect the solenoid body electrical connector.
^ Tighten to 5 Nm (44 inch lbs.).