TorqShift Automatic Transmission

Digital Transmission Range (TR) Sensor

Special Tool(s):

Removal
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Disconnect the shift cable end and position it aside.





3. Remove the transmission fluid pan, gasket and filter.
4. Disconnect the transmission range sensor electrical connector.





5. NOTE: The pin should be driven up through the manual valve.

Remove and discard the manual valve detent lever shaft retaining pin and discard.





6. Using the special tool, remove the manual valve detent lever shaft retaining pin.





7. CAUTION: Be careful not to damage the manual control lever bore.

Remove the manual control lever shaft assembly.





8. Remove the transmission range sensor and detent lever assembly.
1 Remove the bolts.
2 Remove the transmission range sensor and detent lever assembly.
3 Disconnect the park rod from the detent lever assembly.





Installation

Early Build Vehicles With Externally Mounted Remote Filter

CAUTION: Early build vehicles, those equipped with an externally mounted remote filter, are also equipped with a different design sump filter and bottom pan. Always pair the sump filter with the correct bottom pan design, to avoid cavitation, filter cracking and transmission damage.





Late Build Vehicles Without Remote Filter and With Serviceable High Efficiency Sump Filter (HESF)

CAUTION: Late build vehicles replace the remote filter with a serviceable high efficiency sump filter (HESF), which requires a wider and deeper bottom pan. Always pair the sump filter with the correct bottom pan design, to avoid cavitation, filter cracking and transmission damage.





1. Install the transmission range sensor and detent lever assembly.
1 Connect the park rod to the detent lever assembly.
2 Install the transmission range sensor and the detent lever assembly.
3 Loosely install the bolts.





2. Install the manual control lever shaft.





3. NOTE: Leave a small portion of the pin exposed.

Install the manual valve detent lever shaft retaining pin into the case.





4. NOTE: When the retaining pin is installed correctly, 2 mm (0.08 inch) of the pin will be exposed.

Install a new manual valve detent lever shaft retaining pin.





5. Tighten the bolts to 10 Nm (89 inch lbs.)





6. Connect the transmission range sensor electrical connector.





7. Install the transmission fluid pan, gasket and filter.
8. Connect the shift cable end.





9. Adjust the shift linkage. Verify that the vehicle starts in PARK and NEUTRAL and the reverse lamps illuminate in REVERSE.