Steering Column Multifunction Switch
Steering Column Multifunction SwitchRemoval and Installation
1. Depower the supplemental restraint system (SRS). For additional information, refer to Air Bag Systems.
2. Remove the ignition switch lock cylinder.
^ Insert the ignition key into the lock cylinder and turn the ignition switch to the RUN position.
^ Push the ignition switch lock cylinder release tab with a punch while pulling out the ignition switch lock cylinder.
3. If equipped, remove the tilt release lever/handle.
4. Remove the 3 screws and the steering column shrouds.
5. Remove the 2 screws and the multi-function switch.
^ To install, tighten to 3 Nm (27 inch lbs.)
6. Disconnect the multi-function switch electrical connectors.
7. To install, reverse the removal procedure.
8. Repower the supplemental restraint system (SRS). For additional information, refer to Air Bag Systems.