Hood Latch Release Handle - Primary

HOOD LATCH RELEASE HANDLE - PRIMARY

Material:

Material

Part 1:

Part 2:

Exploded View

Removal and Installation
1. Remove the 7 pin-type retainers and the radiator upper sight shield.

2. NOTE: Mark the location of the hood latch with a permanent type marker.

Remove the 2 hood latch bolts and position the hood latch aside.
- To install, tighten to 12 Nm (9 lb-ft).

3. Disconnect the primary hood latch release cable.
4. Remove the A-pillar lower trim panel.
5. Remove the primary hood latch release cable screw.
- To install, tighten to 9 Nm (80 lb-in).

6. Release the cable locators and remove the primary hood latch release cable.
7. To install, reverse the removal procedure.
- When the hood latch is installed, the latch adjustment must be checked to make sure the latch is installed and aligned correctly.
- Lubricate the hood latch after installation.