Seat - Rear, Bench, Crewcab

SEAT - REAR, BENCH, CREWCAB

Removal and Installation

NOTE: New bolts must be installed, do not reuse the bolts that were removed. Studs and nuts can be reused.

1. Remove the seat mounting retainer covers.







2. NOTE: Removing the rear seat requires more than one technician.

Remove the rear seat.
- Remove and discard the mounting bolts.
- To install, tighten to 55 Nm (41 lb-ft).

- Remove the mounting nuts and remove the seat.
- To install, tighten to 55 Nm (41 lb-ft).

3. NOTE: When installing the seat, tighten the 2 new front mounting bolts, then the 2 rear mounting nuts.

To install, reverse the removal procedure.
- Make sure the safety belt is not twisted prior to installation.
- Make sure the safety belts and buckles are accessible to the occupants after installation.