Clutch Drag Inspection and Verification

Clutch Drag Inspection and Verification
1. Verify that the clutch hydraulic fluid reservoir is filled to the correct level.
^ If the fluid level is correct, proceed to the next step in this procedure.
^ If the fluid level is low, add fluid as necessary. Inspect the clutch hydraulic system for leaks and repair as necessary. Test the system for normal operation. Proceed to the next step in this procedure, if necessary.
2. Depress and release the clutch pedal to check for a spongy pedal.
^ If the pedal feels OK, proceed to the next step in this procedure.
^ If the pedal feels spongy, bleed the clutch hydraulic system. Refer to Clutch System Bleeding - In-Vehicle. Test the system for normal operation. Proceed to the next step in this procedure, if necessary.
3. Remove the clutch disc and pressure plate. Inspect the clutch disc and pressure plate for wear and damage, and check the clutch disc runout. Refer to Clutch Pressure Plate Check and Clutch Disc Check. Repair all components as necessary. Test the system for normal operation. Testing and Inspection Testing and Inspection