Seat - Front

SEAT - FRONT

Exploded View

Front Seat Backrest - With Seat Integrated Restraints (SIR):

Front Seat Backrest - Without Seat Integrated Restraints (SIR):

Front Seat Cushion - Driver (Part 1):

Front Seat Cushion - Driver (Part 2):

Front Seat Cushion - Passenger (Part 1):

Front Seat Cushion - Passenger (Part 2):

Removal

WARNING:
- Always wear eye protection when servicing a vehicle. Failure to follow this instruction may result in serious personal injury.
- Never probe the electrical connectors on safety belt buckle/retractor pretensioners or adaptive load limiting retractors. Failure to follow this instruction may result in the accidental deployment of the safety belt pretensioners or adaptive load limiting retractors, which increases the risk of serious personal injury or death.

NOTE:
- The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

1. Move the seat fully rearward.
2. Remove the 2 seat-to-floor front bolts.
3. Move the seat to the most forward position.
4. Depower the SRS.
5. Remove the 2 seat-to-floor rear bolts.

6. NOTE: Additional component connectors may exist due to vehicle options.

Disconnect the electrical connector(s).

7. Remove the seat from the vehicle.

Installation
1. Position the seat in the vehicle.
2. Connect the electrical connector(s).
3. Install the 2 seat-to-floor rear bolts in the following sequence:
- Install the outboard seat-to-floor rear bolt.
- Tighten to 48 Nm (35 lb-ft).

- Install the inboard seat-to-floor rear bolt.
- Tighten to 48 Nm (35 lb-ft).

4. Repower the SRS.
5. Move the seat fully rearward.
6. Install the 2 seat-to-floor front bolts.
- Tighten to 48 Nm (35 lb-ft).