Pinpoint Test G: DTC U0140

Parking Aid

Pinpoint Tests

Pinpoint Test G: DTC U0140

Normal Operation

The Parking Aid Module (PAM) receives the ignition switch state from the Smart Junction Box (SJB) as a network message.

- DTC U0140 (Lost Communication With Body Control Module (GEM)) - a continuous and on-demand DTC that sets in the PAM when ignition switch state messages are not received from the SJB.

This pinpoint test is intended to diagnose the following:

- SJB
- Networked data fault



PINPOINT TEST G: DTC U0140

-------------------------------------------------
G1 VERIFY THE CUSTOMER CONCERN


- Ignition ON.
- Verify that there is an observable symptom present.
- Is an observable symptom present?

Yes
GO to G2.

No
The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.

-------------------------------------------------
G2 CHECK THE COMMUNICATION NETWORK


- Ignition ON.
- Enter the following diagnostic mode on the scan tool: Network Test.
- Carry out the network test.
- Does the SJB pass the network test?

Yes
GO to G3.

No
REFER to Information Bus.

-------------------------------------------------
G3 RECHECK THE PAM DTCs


NOTE: If new modules were installed prior to the DTC being set, the module configuration may be incorrectly set during Programmable Module Installation (PMI) or the PMI may not have been carried out.

- Clear the DTCs. Repeat the PAM self-test.
- Is DTC U0140 still present?

Yes
GO to G4.

No
The system is operating correctly at this time. The DTC may have been set due to high network traffic.

-------------------------------------------------
G4 CHECK FOR DTC U0140 SET IN OTHER MODULES


- Clear all DTCs.
- Ignition OFF.
- Ignition ON.
- Wait 10 seconds.
- Enter the following diagnostic mode on the scan tool: Self-Test.
- Retrieve the continuous memory DTCs from all modules.
- Is DTC U0140 set in any module?

Yes
INSTALL a new SJB. REFER to Body Control Systems. TEST the system for normal operation.

No
INSTALL a new PAM. REFER to Parking Aid Module (PAM) Service and Repair. TEST the system for normal operation.

-------------------------------------------------