Seat - Front, 20 Percent

Seat - Front, 20 Percent









Removal

All vehicles

1. Remove the front seats. For additional information, refer to Seat - Front, Bucket Seat Seat - Front, Bucket Seat.

Regular cab vehicles

2. Using an appropriate tool, push in the pin hole while pulling the safety belt tongue out of the safety belt buckle.





All vehicles

3. Remove and discard the 20 percent seat riser-to-floor RH rear bolt.

4. Remove the 20 percent seat riser-to-floor LH rear nut.

5. Remove the seat.

Installation

NOTE: New bolts must be installed, do not reuse the bolts that were removed.

NOTE: Before installation, make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.

All vehicles

1. Position the seat in the vehicle.

2. Position the safety belt anchor. Install the 20 percent seat riser-to-floor LH rear nut.
- Tighten to 55 Nm (41 lb-ft).

3. Install the new 20 percent seat riser-to-floor RH rear bolt.
- Tighten to 55 Nm (41 lb-ft).

4. Install the front seats. For additional information, refer to Seat - Front, Bucket Seat Seat - Front, Bucket Seat.

Regular cab vehicles

5. Attach the center safety belt retractor tongue into the safety belt buckle.