Oil Pressure Regulator

Oil Pressure Regulator













Removal

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.

2. Remove the oil pressure regulator plug, spring and valve from the oil pump.
- Remove and discard the O-ring seal.

- Inspect the oil pressure regulator components and bore for wear. Install new components as necessary.

Installation

1. NOTE: Install a new O-ring seal on the oil pressure regulator plug.

Apply clean engine oil to the oil pressure regulator plug O-ring seal, spring and valve and install in the oil pump.

- Tighten to 35 Nm (26 lb-ft).