Inspection and Verification

Anti-Lock Control - Three-Channel

Inspection and Verification

NOTE: If a new ABS module is installed, it must be configured. Refer to Programmable Module Installation (PMI) in Module Configuration Programmable Module Installation (PMI).

1. Verify the customer concern.

2. Verify the stoplamps operate correctly by applying and releasing the brake pedal with the ignition in the OFF position. If the stoplamps do not operate correctly, refer to Diagnosis and Testing in Exterior Lighting Testing and Inspection. If the stoplamps operate correctly, proceed to the next step.

3. Visually inspect for obvious signs of mechanical or electrical damage.

Visual Inspection Chart





4. NOTE: Make sure to use the latest scan tool software release.

If the cause is not visually evident, connect the scan tool to the Data Link Connector (DLC).

5. NOTE: The Vehicle Communication Module (VCM) LED prove out confirms power and ground from the DLC are provided to the VCM.

If the scan tool does not communicate with the VCM:

- check the VCM connection to the vehicle.

- check the scan tool connection to the VCM.

- refer to Module Communications Network Testing and Inspection, No Power To The Scan Tool, to diagnose no power to the scan tool.

6. If the scan tool does not communicate with the vehicle:
- verify the ignition is in the ON position.

- verify the scan tool operation with a known good vehicle.

- refer to Module Communications Network Testing and Inspection, The PCM Does Not Respond To The Scan Tool, to diagnose no response from the PCM.

7. Carry out the network test.
- If the scan tool responds with no communication for one or more modules, refer to Module Communications Network Testing and Inspection to diagnose the no communication concern.

- If the network test passes, retrieve and record continuous memory DTCs.

8. Clear the continuous DTCs and carry out the self-test diagnostics for the ABS module.

9. If the DTCs retrieved are related to the concern, go to the ABS Module DTC Chart Anti-Lock Control - Three-Channel. For all other DTCs, refer to Multifunction Electronic Modules Testing and Inspection.

10. If no DTCs related to the concern are retrieved, GO to Symptom Chart - Three-Channel. Anti-Lock Control - Three-Channel