Pinpoint Tests BI: DTC U0212:00

Instrumentation, Message Center and Warning Chimes

Pinpoint Tests

Pinpoint Test BI: DTC U0212:00

Normal Operation
- DTC U0212:00 (Lost Communication With Steering Column Control Module: No Sub-Type Information) - sets in continuous memory in the Instrument Panel Cluster (IPC) if data messages received from the Steering Column Control Module (SCCM) over the High Speed Controller Area Network (HS-CAN) are missing for 5 seconds or longer. For a complete list of all network messages, refer to Module Communications Network Testing and Inspection.

This pinpoint test is intended to diagnose the following:

- SCCM
- IPC

PINPOINT TEST BI: DTC U0212:00

-------------------------------------------------
BI1 VERIFY THE CUSTOMER CONCERN

- Ignition ON.
- Verify there is an observable symptom present.
- Is an observable symptom present?

Yes
GO to BI2.

No
The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.

-------------------------------------------------
BI2 CHECK THE COMMUNICATION NETWORK

- Ignition ON.
- Enter the following diagnostic mode on the scan tool: Network Test.
- Carry out the network test.
- Does the SCCM pass the network test?

Yes
GO to BI3.

No
REFER to Module Communications Network Testing and Inspection.

-------------------------------------------------
BI3 RETRIEVE THE RECORDED DTCs FROM THE IPC SELF-TEST

- Check for recorded DTCs from the IPC self-test.
- Is DTC U3003:16 or DTC U3003:17 recorded?

Yes
For DTC U3003:16, GO to Pinpoint Test BK. For DTC U3003:17, GO to Pinpoint Test BL. Pinpoint Tests BK: DTC U3003:16 Pinpoint Tests BL: DTC U3003:17

No
GO to BI4.

-------------------------------------------------
BI4 RECHECK THE IPC DTCs

- Clear the DTCs.
- Wait 10 seconds.
- Repeat the IPC self-test.
- Is DTC U0212:00 still present?

Yes
GO to BI5.

No
The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.

-------------------------------------------------
BI5 CHECK FOR DTC U0212:87 SET IN OTHER MODULES

- Clear all DTCs.
- Ignition OFF.
- Ignition ON.
- Wait 10 seconds.
- Enter the following diagnostic mode on the scan tool: Self-Test.
- Retrieve the continuous memory DTCs from all modules.
- Is DTC U0212:87 set in the Body Control Module (BCM)?

Yes
INSTALL a new SCCM. CLEAR the DTCs. REPEAT the self-test.

No
INSTALL a new IPC. REFER to Instrument Panel Cluster (IPC) Instrument Panel Cluster (IPC). TEST the system for normal operation.

-------------------------------------------------