Diagnostics - TorqShift(R)

Diagnostics - TorqShift(R)





Diagnosing an electronically controlled automatic transmission is simplified by using the following procedures. One of the most important things to remember is that there is a definite procedure to follow. DO NOT TAKE SHORT CUTS OR ASSUME THAT CRITICAL CHECKS OR ADJUSTMENTS HAVE ALREADY BEEN MADE. Follow the procedures as written to avoid missing critical components or steps. By following the diagnostic sequence, the technician will be able to diagnose and repair the concern the first time.

On-Board Diagnostic (OBD) with Scan Tool

These self-tests should be used to diagnose the PCM and should be carried out in order.

NOTE: Make sure to use the latest scan tool software release.

1. If the cause is not visually evident, connect the scan tool to the Data Link Connector (DLC).

NOTE: The Vehicle Communication Module (VCM) Light Emitting Diode (LED) prove-out confirms power and ground from the DLC to the VCM.

2. If the scan tool does not communicate with the VCM:
- check the VCM connection to the vehicle.

- check the scan tool connection to the VCM.

- refer to Module Communications Network Testing and Inspection to diagnosis no power to the scan tool.

3. If the scan tool does not communicate with the vehicle:
- verify the ignition is in the ON position.

- verify scan tool operation with a known good vehicle.

- refer to Module Communications Network Testing and Inspection to diagnosis no response from the PCM.

4. Carry out the network test. If the scan tool responds with no communication from one or more modules, refer to Module Communications Network Testing and Inspection. If the network test passes, read and record the continuous memory DTCs.

5. Clear the continuous DTCs and carry out the PCM self-test.

6. If DTCs are related to the concern, go to the DTC Chart. [1][2]Diagnostic Trouble Code Descriptions

7. If DTCs are not related to the concern, refer to Diagnosis By Symptom Diagnosis By Symptom.