Seat - Front

Seat - Front

Removal and Installation

NOTE: LH shown, RH similar.









WARNING: Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors. Failure to follow this instruction may result in the accidental deployment of the safety belt pretensioners, adaptive load limiting retractors, or safety belt inflators, which increases the risk of serious personal injury or death.

NOTE: The air bag warning indicator illuminates when the correct Restraints Control Module (RCM) fuse is removed and the ignition is ON.

NOTE: The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.

1. Position the seat to gain access to all seat mounting fasteners.

2. Depower the SRS (Supplemental Restraint System). For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures portion of Restraints and Safety Systems &/or Air Bag Systems.

3. Disconnect the electrical connector(s).
1. Disconnect the safety belt buckle pretensioner electrical connector.

2. If equipped, disconnect the power seat track electrical connector.






4. Remove the caps and 2 rear mounting nuts.
- To install, tighten to 55 Nm (41 lb-ft).


5. Remove the 2 front mounting bolts and remove the seat.
- To install, tighten to 55 Nm (41 lb-ft).


6. To install, reverse the removal procedure.

7. Repower the SRS (Supplemental Restraint System). For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures portion of Restraints and Safety Systems &/or Air Bag Systems.