Ignition Switch: Service and Repair

Ignition Switch









Removal and Installation

1. Depower the Supplemental Restraint System (SRS). For additional information, refer to Restraints and Safety Systems &/or Air Bag Systems.

2. Remove the steering column opening cover and the instrument panel LH knee bolster.

3. Disconnect the ignition switch electrical connector.

4. Remove the 2 ignition switch screws and the ignition switch.
- To install, align the ignition switch with the slot and index mark on the steering column and tighten the screws to 6 Nm (53 lb-in).


5. To install, reverse the removal procedure.

6. Repower the SRS (Supplemental Restraint System). For additional information, refer to Restraints and Safety Systems &/or Air Bag Systems.