DRW
BRAKE PADS/SHOES - REARREMOVAL (DRW)
1. Unscrew the cap from the brake fluid reservoir.
2. Raise and support the vehicle.
3. Remove the rear wheels.
4. Remove the wear indicator cable and the wear indicator (Fig. 8).
NOTE: Seal off the line ends and connection threads in the brake calipers with plugs. Also check brake hoses for signs of cracks.
5. Remove the brake caliper guide pins (Fig. 8).
6. Remove the brake caliper from the caliper adapter (Fig. 8).
7. Remove the retaining spring (Fig. 8).
8. Remove the Dads (Fig. 8).
INSTALLATION (DRW)
1. Install the brake pads (Fig. 8).
2. Install the wear indicator cable and the wear indicator (Fig. 8). Tighten to 10 Nm (89 inch lbs.).
NOTE: Do not install the brake hose twisted and ensure freedom of movement.
3. Install the brake caliper to brake caliper adapter (Fig. 8). Tighten the guide pins to 25 Nm (221 inch lbs.) for M8 bolt or 30 Nm (266 inch lbs.) for M10 10.9 bolt.
4. Install the retaining spring (Fig. 8).
5. Install the rear wheels.
6. Lower the vehicle.