License Plate Lamp Unit Replacement

REMOVAL
1. Disconnect and isolate the battery negative cable.

License Plate Lamp Unit Remove/Install:

2. Using hand pressure, press the right side of the license plate lamp housing toward the left against the spring pressure of the retaining clip, then pull the right side of the lamp downward to disengage it from the mounting hole.
3. Pull the license plate lamp housing slightly to the right to disengage the left side of the unit from the mounting hole.
4. Disconnect the one or two vehicle wire harness connections from the terminals on the back of the license plate lamp unit.
5. Remove the license plate lamp unit from the vehicle.

INSTALLATION
1. Position the license plate lamp unit to the mounting hole on the vehicle.
2. Reconnect the one or two vehicle wire harness connections to the terminals on the back of the license plate lamp unit.
3. Engage the left side of the license plate lamp unit into the left side of the mounting hole.
4. Using hand pressure, press the right side of the license plate lamp housing toward the left against the spring pressure of the retaining clip, then push the right side of the lamp upward to engage it into the right side of the mounting hole.
5. Reconnect the battery negative cable.