Removal

ELECTROHYDRAULIC UNIT

REMOVAL





1. Drain transmission oil by unscrewing oil drain plug (8) (Fig. 120).

NOTE: If the transmission fluid is burnt or contains abraded particles, the oil cooler lines and oil cooler must be flushed out.

2. Move selector lever to position "P".
3. Raise vehicle.





4. Remove bolt (3) (Fig. 121) and screw (1) holding the heat shield (2) to the transmission.





5. Disconnect 13 pin plug connector (1) (Fig. 122). Turn bayonet lock of guide bushing (2) anti clockwise.
6. Loosen guide bushing (2) and remove from transmission housing.





7. Detach oil pan (5) (Fig. 123).
8. Remove oil filter (4).
9. Unscrew Torx socket bolts (3) and remove electrohydraulic control module (2).