Valve Body & Associated Parts

1. Install 3-4 accumulator pin into case, then the 3-4 accumulator piston seal onto the 3-4 accumulator piston.

2. Install 3-4 accumulator piston onto the pin. End with three legs should face valve body.





3. Install 3-4 accumulator piston spring.

4. Install governor and converter clutch oil screens.





5. Install check balls in case as shown in Figure, then tool No. J25025-5 into the case.

6. Install spacer plate to case gasket. Gasket is identified by a "C" marking.

7. Install spacer plate, then the valve body to spacer plate gasket. Gasket is identified by a "V" marking.