Disassemble Housing
1. Remove pitman, shaft outer dust seal retaining ring.
2. Remove outer dust seal.
3. Remove seal (double lip) by inserting offset screwdriver between seal and back-up washer and prying out of housing.
4. Remove back-up washer.
5. Remove seal (single lip) by cutting and collapsing seal.
6. Remove pitman shaft needle bearings (if necessary) with a suitable driver.
7. If connectors are to be removed, tap threads in holes of connectors using 5/16-18 NF tap. Remove connectors by using threaded bolt into tapped holes with washer and nut as extractor.