With V5 Compressor

Compressor Components:

Compressor Shaft Seal:

Remove or Disconnect

Tools Required:
J 5403 Internal Snap Ring Pliers
J 9553-01 O-Ring Seal Remover:
J 23128-A Seal Remover and Installer
J 34614 Shaft Seal Protector

1. Clutch plate and hub assembly (22).

Removing Or Installing The Shaft Seal Retainer:

2. Shaft seal retainer ring using J 5403.
^ Clean the compressor neck area around the shaft (38), the exposed part of the shaft seal (29) and the O-ring seal groove. Any dirt or foreign material getting into the compressor may cause damage.

Removing Or Installing The Shaft Seal:

3. Shaft lip seal using J 23128-A.
^ Install J 34614 over the threaded end of the shaft (20).
^ Insert J 23128-A into the shaft lip seal, tighten and remove lip seal.

Removing The Shaft Seal Seat O-Ring:

4. O-Ring seal using J 9553-01.

Inspect
^ Make sure the compressor neck area is clean.
^ All parts. Replace as necessary.

Install or Connect

Tools Required:
J 5403 Internal Snap Ring Pliers
J 23128-A Seal Seal Remover and Installer.
J 33011 O-Ring Seal Installer
J 34614 Shaft Seal Protector

^ Dip the new O-ring seal in clean 525 viscosity refrigerant oil.
1. J 34614 onto the shaft.

Installing The Shaft Seal Seat O-Ring:

2. O-ring seal using J 33011.
^ Insert J 33011 into the compressor neck until the installer "bottoms."
^ Lower the movable slide of J 33011, releasing the O-ring seal into the lower groove.
^ Rotate J 33011 to seat the O-ring seal and remove J 33011.
3. Shaft lip seal using J 23128-A.
^ Dip the shaft lip seal in clean 525 viscosity refrigerant oil and install shaft lip seal on J 23128-A
^ Bottom the shaft lip seal into the compressor neck area using J 23128-A.
4. Shaft seal retainer ring using J 5403.
^ Install flat side of shaft seal retainer ring against the lip seal.
^ Remove J 34614.

Important
^ Leak test the compressor.

Clean
^ Shaft and inside the compressor neck area.

5. Clutch plate and hub assembly (22).