Shaft Seal

Remove or Disconnect

Tools Required:
J 5403 Snap Ring Pliers
J 9553-01 O-ring Remover
J 23128-A Seal Remover

Removing The Shaft Seal With J 23128-A:

1. Retainer ring using J 5403.
2. Shaft seal.
^ Engage the knurled tangs of J 23128-A into the recessed portion of the seal by turning the handle clockwise.

Removing And Installing The Shaft Seal:

3. O-ring using J 9553-01.

Install or Connect

Tools Required:
J 5403 Snap Ring Pliers
J 23128-A Seal Installer
J 33011 O-ring Installer
J 34614 Seal Protector

Installing The Seal:

1. New O-ring seal, dipped in 525 refrigerant oil, onto J 33011.
2. O-ring completely down on the shaft until it bottoms.

Important
^ The seal seat and the seal lip must be free of lint or dirt.

3. Lip seal to J 23128-A.
^ The printed/stamped side of the seal must be engaged with the knurled tangs of J 23128-A so that the flared out side of the seal is facing the compressor.

NOTICE: Handling the care of seal protector is important. If the seal protector is nicked or the bottom flared, the new seal may be damaged during installation.

4. J 34614 on the shaft.
5. Lip seal. Disengage installer by turning it counter-clockwise.
6. Retainer ring, flat side against the seal seat using J 5403. Use J 33011 to seat the retainer in its groove.