Hub & Drum

REAR WHEEL BEARINGS

Fig. 6 Removing Or Installing Wheel Bearing Adjusting Nut:

1. Remove wheel and axle shaft.
2. Disengage tang of locknut from slot or flat of locknut, then remove locknut from housing tube, using appropriate tool, Fig. 6.
3. Disengage tang of locknut from slot or flat of adjusting nut and remove locknut from housing tube.
4. Use appropriate tool, Fig. 6, to remove adjusting nut from housing tube. Remove thrust washer from housing tube.
5. Pull hub and drum straight off axle housing.