Ignition Lock Cylinder & Shrouds

LOWER SHROUD
STRG COLUMN LOCK CYL SET
UPPER SHROUD
SHIFT LEVER SEAL (column shift only)


















^ Tools Required:
- J 41352 Modular Column Holding Fixture
- Or Equivalent

Remove or disconnect the following:
1. Negative (-) battery cable.
2. Disable the SIR system; refer to Disabling And Enabling The SIR System.
3. Lower or remove steering column from vehicle.

CAUTION: Once steering column is removed from vehicle, the column is extremely susceptible to damage.





- Secure steering column to modular column holding fixture J 41352.
- Place holding fixture into vise.





- Inspect the steering shaft assembly for accident damage.

4. Tilt lever.
5. Two pan head tapping screws (13) from lower shroud (28).
6. Lower shroud (28).
- Tilt shroud (28) down and slide back to disengage locking tabs.
7. Two TORX(R) head screws (14) from upper shroud (10).
8. Lift upper shroud (10) to gain access to lock cylinder hole.
a. Hold key in "START" position.
b. Using 1/16-inch alien wrench push on lock cylinder retaining pin.
c. Release key to "RUN" position and pull steering column lock cylinder set (17)from lock module assembly (15).
d. Remove upper shroud (10).
9. Shift lever.
10. Shift lever seal (16).
11. Shroud protector (27) from lower shroud (28).

INSTALLATION
Install or connect the following:

CAUTION: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion Inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems.

1. Shift lever seal (16).
2. Shift lever.
3. Shroud protector (27) to lower shroud (28).
4. Move shift lever seal (16) and multifunction lever seal to ease in installation of upper and lower shrouds.
5. Upper shroud (10) and steering column lock cylinder set (17).
a. Key installed in lock cylinder (17) and in "RUN" position.





b. Ensure sector in lock module assembly (15) is in "RUN" position.
c. Lock cylinder (17) to upper shroud (10).
d. Line up locking tab and positioning tab with slots in lock module assembly (15) and push cylinder (17) into position.
6. Two TORX(R) head screws (14) to upper shroud (10). Tighten (14) to 1.4 Nm (12 lb in).
7. Lower shroud (28).
- Ensure that slots on lower shroud (28) engage with tabs on upper shroud (10).
- Tilt lower shroud up and snap shrouds together.
8. Two pan head tapping screws (13) to lower shroud (28). Tighten (13) to 6.0 Nm (53 lb in).
9. Shift lever seal (16) and multifunction lever seal into position.
10. Tilt lever.
11. Raise or install steering column to vehicle.
12. If all service operations are completed, enable the SIR system.
13. Negative (-) battery cable.