Upper Tilt Head Components

^ Tools Required:
- J 23653-SIR Lock Plate Compressor
- Or Equivalents

REMOVAL
Remove or disconnect the following:
1. Do Removal steps 1 through 4 in Coil Replacement. Let coil assembly (2) hang freely.
2. Shaft lock retaining ring (4) using J 23653-SIR to push down shaft lock shield assembly (5). Dispose of ring (4).
3. Shaft lock shield assembly (5).
4. Turn signal cancel cam assembly (6).
5. Upper bearing spring (7).
6. Upper bearing inner race seat (8).
7. Inner race (93.


INSTALLATION

CAUTION: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion Inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems.

Install or connect the following:
1. Inner race (9).
2. Upper bearing inner race seat (8).
3. Upper bearing spring (7).
4. Turn signal cancel cam assembly (6).
5. Shaft lock shield assembly (5).
- Align inner block tooth of lock plate to block tooth of race & upper shaft assembly (34).
- Lubricate with grease, synthetic (service kit).
6. New shaft lock retaining ring (4) using J 23653-SIR to push down shaft lock shield assembly (5).
- Ring (4) must be firmly seated in groove on shaft.
7. Do installation steps 1 through 3 and 6 through 9 in Coil Replacement.