Tilt Head Assembly

^ Tools Required:
- J 23653-SIR Lock Plate Compressor
- J 21854-01 Pivot Pin Remover

REMOVAL
Remove or disconnect the following:
1. Do all removal steps. Refer to Coil Replacement.
2. Do removal steps 7 and 8. Refer to Turn Signal & Multi Function Switch.
3. Do removal steps 2 through 6. Refer to Linear Shift Assembly Replacement.
4. Do removal steps 2 through 7. Refer to Upper Tilt Head Components.
5. Do removal steps 6 through 8. Refer to Lock Model Assembly.
6. Do removal steps 4 and 5. Refer to Tilt Spring.
7. Two pivot pins (56) using J 21854-01.
8. Steering column tilt head assembly (26). Pull tilt arm to disengage steering wheel lock shoes from dowel pins in steering column support assembly (57).

INSTALLATION

CAUTION: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion Inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems.

Install or connect the following:
1. Steering column tilt head assembly (26).
- Using tilt lever position lock shoes to dowel pins.
- Rotate head assembly (26) until holes for pivot pins (56) line up.
2. Two pivot pins (56).
a. Lubricate with lithium grease.
b. Press pins until firmly seated two places.
c. Stake pins (56) three locations two places.
3. Do installation step 2. Refer to Tilt Spring.
4. Do installation steps 2 through 4. Refer to Lock Model Assembly.
5. Do installation steps 1 through 6. Refer to Upper Tilt Head Components.
6. Do installation steps 1 through 6. Refer to Linear Shift Assembly Replacement (Column shift only) and adjust and inspect in this section.
7. Do all installation steps. Refer to Coil Replacement.