Installation For Cloth Seats

1. Unfasten velcro strip or J-strip from corner of side skirt on seat bottom (Figure 3, Item 1) and pull trim back just enough to uncover the recliner mechanism. Do not remove the lower recliner handle or the seat foam.

2. Loosen trim around the recliner mechanism to allow the protector cover (Figure 4, Item 1) to slide down the top of the recliner mechanism.

3. With your hand, push back the trim on the seat-back to expose the recliner pin (Figure 4, Item 2). Mount the protector cover slotted tab onto the outboard recliner pin (Figure 4, Item 2). When the slotted tab is aligned with the outboard recliner pin, push down on the protector cover, snapping the net hole tab onto the inboard recliner pin. The body of the cover must completely saddle the top surface of the recliner mechanism.

4. Reposition seat bottom trim by tightly refastening at velcro strips or J-strips.

5. Repeat same procedure on outboard side of front passenger seat.

6. Install the GM Campaign Identification Label.