Parking Pawl: Service and Repair

REMOVAL

1. Drain and remove oil pan, then filter and gasket.

Fig. 16 Park Lock Assembly.:

2. Remove lever retaining nut, then pin Fig. 16.
3. Remove detent lever and actuator assembly.
4. Remove parking pawl bracket, spring and pawl return spring plug.
5. Remove parking pawl shaft hole plug, retainer, shaft and pawl.
6. Remove manual shift shaft seal assembly and shaft.
7. Remove speed sensors.

INSTALLATION

1. Install pawl shaft and parking pawl.
2. Install parking lock pawl plug with Loctite using a 7/16 inch rod.
3. Install retainer, stud and pawl return spring.
4. Install detent lever to actuator assembly.
5. Install actuator assembly over parking pawl.
6. Install manual shaft and seal.
7. Install lever nut on shaft.
8. Install roll pin, then parking lock bracket. Tighten bolts to specifications.