Antenna, Radio: Service and Repair

REMOVAL PROCEDURE
1. Disconnect the antenna mast (1).
2. Remove the nut (2).
3. Remove the bezel (3).
4. Disconnect the antenna cable from the extension cable (6).
5. Remove the screws (5).
6. Disconnect the cable assembly.

INSTALLATION PROCEDURE
1. Connect the antenna cable assembly.

NOTE: Refer to Fastener Notice in Cautions and Notices.

2. Install the screws (5).

Tighten
Tighten the screws to 5 N.m (58 lb in).

3. Connect the antenna cable to the extension cable (6).
4. Install the bezel (3).
5. Install the nut (2).

Tighten
Tighten the nut to 5 N.m(58 lb in).

6. Install the antenna mast (1).