Steering Column Housing Assembly

^ Tools Required:
- J 23653-SIR Lock Plate Compressor
- J 41396 Park Lock Cable Pliers

REMOVE OR DISCONNECT
1. Do all steps, "REMOVE OR DISCONNECT", COIL ASSEMBLY.
2. Do steps 2 through 7, "REMOVE OR DISCONNECT", T/S & MULTIFUNCTION SWITCH ASSEMBLY.
3. Do steps 2 through 6, "REMOVE OR DISCONNECT" LINEAR SHIFT ASSEMBLY (REMOVAL).
4. Do steps 2 through 6, "REMOVE OR DISCONNECT", UPPER COLUMN HOUSING COMPONENTS.
5. Do steps 2 through 9, "REMOVE OR DISCONNECT", LOCK MODULE ASSEMBLY.
6. Four tore head screws (9).
7. Steering column housing assembly (26).

INSTALL OR CONNECT

NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems.

1. Steering column housing assembly (26).
2. Four torx head screws (9).

Tighten
^ Tighten screws (9) to 17 Nm (13.5 lb ft)

3. Do steps 1 through 8, "INSTALL OR CONNECT", LOCK MODULE ASSEMBLY.
4. Do steps 1 through 5, "INSTALL OR CONNECT", UPPER COLUMN HOUSING COMPONENTS.
5. Do steps 1 through 5, "INSTALL OR CONNECT", LINEAR SHIFT ASSEMBLY (REMOVAL), and Adjust and Inspect.
6. Do steps [through 6, "INSTALL OR CONNECT", T/S & MULTIFUNCTION SWITCH ASSEMBLY.
7. Do all steps,"INSTALL OR CONNECT", COIL ASSEMBLY.