Transmission Oil Pump Assemble

- Tools Required
- J 21368 Alignment Band
- J 36850 Transjel(r)





1. Assemble the oil pump cover (206) and the oil pump body (203).

IMPORTANT: The round end on the splash shield fits into the hole in the oil pump cover. The slotted hole in the splash shield fits under the bolt head.





2. Install the vent passage splash shield (239).
3. Install the remaining oil pump cover bolts (220). Tighten the bolts with your fingers.





4. Install an oil pump to case bolt (3) into the oil pump bolt hole.

IMPORTANT: The outside diameter of the oil pump body and oil pump cover must be properly aligned and then the alignment band can be tightened. This ensures that the oil pump will fit into the transmission case opening and maintains maximum oil pump efficiency.

5. Install J 21368 onto the transmission oil pump assembly and tighten.
6. Install the five oil pump cover bolts (220).
- Tighten the bolts to 24 Nm (18 ft. lbs.).

7. Remove the J 21368 and the pump to case bolt (3).

IMPORTANT: Coat the oil pump O-ring seal with J 36850 or equivalent. This will ease assembly and prevent damage to the seal.





8. Install the transmission oil pump O-ring seal (5).

NOTICE: Do not overexpand the oil seal as it may become damaged.





9. Install the new oil seals onto the oil pump.
10. Use J 36850 or equivalent in order to keep the seals in place.