Ignition & Key Alarm Switch

Standard Steering Column:

Standard Steering Column - Legend:

^ Tools Required:
- J 41352 Modular Column Holding Fixture
- Or Equivalent

REMOVE OR DISCONNECT
1. Do removal steps 1 through 7, Refer to Lower Shroud Steering Column Lock Cylinder Set Upper Shroud Shift Lever Seal.
2. Do removal steps 2 through 6, Refer to T/S & Multifunction Switch Assembly.

Removing Alarm Switch:

3. Alarm switch from lock module assembly (15).
- Gently pry retaining clip on alarm switch with small blade screwdriver.
- Rotate alarm switch 1/4 turn and remove.
4. Two tapping screws (18).

Removing Ignition & Key Alarm Switch:

5. Ignition & key alarm switch assembly (19).
- Wire harness from slot in steering column housing assembly (26).

INSTALL OR CONNECT

CAUTION: Always use the correct fastener In the proper location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion Inhibitors) on threaded fasteners or fastener pint Interfaces. Generally, such coatings adversely affect the fastener torque and pint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these Instructions can help you avoid damage to parts and systems. Failure to do may result in component damage or malfunction of steering column.

1. Ignition & key alarm switch assembly (19).
- Route wire harness through slot in steering column housing assembly (26). Secure wire harness with a wire harness strap (22) through hole located in the bottom of housing assembly (26).
2. Two tapping screws (18). Tighten (18) to 1.4 Nm (12 lb in).
3. Alarm switch to lock module assembly (15).
a. Switch with retaining clip parallel to lock cylinder (17).
b. Rotate switch 1/4 turn until locked into place.
4. Do installation steps 3 through 8, Refer to T/S & Multifunction Switch Assembly.