Turn Signal & Multifunction Switch

Tilt Steering Column:

Tilt Steering Column - Legend:

Removing T/S & Multifunction Switch:

^ Tools Required:
- J 41352 Modular Column Holding Fixture
- Or Equivalent

REMOVE OR DISCONNECT
1. Do removal steps 1 through 7, Refer to Lower Shroud Steering Column Lock Cylinder Set Upper Shroud Shift Lever Seal.
2. Two wire harness straps (22) from steering column wire harness.
3. Steering column bulkhead connector from vehicle wire harness.
4. Axial position assurance connector (23) from electrical BTSI actuator (61). (column shift only)
- Electrical connector from BTSI actuator (61).
5. Grey and black connectors of turn signal & multi function switch (24) from column bulkhead connector.
6. Two pan head tapping screws (13).
7. Turn signal & multifunction switch assembly (24) from column.

INSTALL OR CONNECT

CAUTION: Always use the correct fastener In the proper location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion Inhibitors) on threaded fasteners or fastener pint Interfaces. Generally, such coatings adversely affect the fastener torque and pint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these Instructions can help you avoid damage to parts and systems. Failure to do may result in component damage or malfunction of steering column.

1. Turn signal & multifunction switch assembly (24) to column.
- With small blade screwdriver compress electrical contact and move multi-function switch (24) into position.
- Electrical contact must rest on cancelling cam assembly (6).
2. Two pan head tapping screws (13).
- Tighten screws (13) to 6.0 Nm (53 lb in).
4. Grey and black connectors of multi-function switch (24) to column bulkhead connector. Electrical connector to electrical BTSI actuator (61).
- Axial position assurance connector (23).
5. Steering column bulkhead connector to vehicle wire harness.
6. Two wire harness straps (22) to steering column wire harness. Do installation steps 4 through 10, Refer to Lower Shroud Steering Column Lock Cylinder Set Upper Shroud Shift Lever Seal.