Mirror Replacement - Power Mirror

Mirror Replacement (Power Mirror)

Removal Procedure

1. Remove the trim panel upper extension.




2. Remove the insulator, if equipped.
3. Remove the front door trim panel.
4. Remove the water deflector.
5. Disconnect the mirror wiring harness from the door.




6. Remove the nuts securing the outside mirror to the door.
7. Remove the mirror from the door.

Installation Procedure




1. Install the outside mirror to the door. Press the mirror into place.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the nuts in order to secure the outside mirror to the door.

Tighten the outside mirror nuts to 9 N.m (80 lb in).

3. Connect the mirror wiring harness to the door.
4. Install the water deflector.




5. Install the front door trim panel.
6. Install the insulator, if equipped.
7. Install the trim panel upper extension.

Important: After servicing the power-folding mirrors, it is necessary to ensure that they are set in the full locked position. The mirror housing must be fully retracted inboard and then extended to its outboard position to lock the mirror in place. Cycle the power folding mirrors 3 times using the mirror switch on the driver's side door panel in order to fully implement the detent feature of these mirrors. Failure to do this could cause the mirrors to fold inward when the vehicle is at highway speeds.