Instrument Panel (IP) - Trim Panel Replacement - Upper

Trim Panel Replacement - Instrument Panel (I/P) Upper

Removal Procedure

1. If equipped with air conditioning (A/C), set the air flow control to the instrument panel (IP) vent position.
2. Apply the parking brake to prevent the vehicle from moving.
3. If the transmission is automatic, move the shift lever all the way down.
4. Tilt the steering wheel to the full down position.
5. Remove the IP cluster trim plate bezel.




6. Remove the end panels. The left panel is shown, and the right panel is similar.
7. Remove the right side air outlets.




8. Remove the assist handle by depressing the release tabs accessed through the air outlet duct holes.
9. Remove the windshield pillar garnish moldings.
10. Remove the bolts retaining the panel to IP assembly.




11. Lift the trim panel up to disconnect the electrical connector (1) to the ambient light sensor on the underside of the trim panel.




12. Remove the trim panel from the IP assembly.

Installation Procedure




1. Connect the electrical connector (1) to the ambient light sensor on the underside of the trim panel.




2. Install the trim panel to the IP assembly.

Notice: Refer to Fastener Notice in Service Precautions.

3. Install the trim panel retaining screws.

Tighten the trim panel retaining screws to 2 N.m (18 lb in).

4. Install the windshield pillar garnish moldings.




5. Align the assist handle with the holes in the IP assembly. Push the handle in order to engage the retaining tabs.
6. Install the right side air outlets.




7. Install the end panels. The left panel is shown, and the right panel is similar.
8. Install the IP cluster trim plate bezel.
9. Tilt the steering wheel to the normal driving position.
10. If the transmission is automatic, move the shift lever to the park position.
11. Disengage the parking brake.