Steering Gear Thrust Support Replacement - Off Vehicle (700 Gear)

Steering Gear Thrust Support Replacement - Off Vehicle (700 Gear)
^ Tools Required
- J 42882 Adjuster Nut Socket
- J 43435 Adjuster Lock Nut Wrench

Disassembly Procedure





1. Rotate the stub shaft back and forth in order to drain the power steering fluid.
2. Remove the coupling shield retainer and the lock nut from the steering gear housing using J 43435 and a torque wrench.





3. Remove the adjuster nut assembly (2) from the steering gear housing (1) using J 42882.





4. Remove the thrust support assembly (2) from the steering gear housing (1).
5. Remove the O-ring seal (3) from the thrust support assembly (2).

Assembly Procedure





1. Important:
Install a new O-ring seal each time the thrust support assembly is removed from the steering gear.

Lubricate the new O-ring seal (3).

2. Install the new O-ring seal (3) on the thrust support assembly (2).
3. Install the thrust support assembly (2).





4. Connect the adjuster nut assembly (2) to the steering gear housing (1) using J 42882.
5. Install the coupling shield retainer and the lock nut (1) to the adjuster nut assembly.
6. Refer to Worm Thrust Bearing Preload Adjustment - Off Vehicle (700 Gear) to adjust the thrust bearing preload.





7. Hold the adjuster nut assembly in position to maintain alignment of the marks.

8. Notice: Refer to Fastener Notice in Service Precautions.
^ Tighten the coupling shield retainer and the lock nut using J 43435 and a torque wrench.
^ Tighten the retainer and the lock nut to 109 Nm (80 ft. lbs.).