Radio/Stereo: Service and Repair

RADIO REPLACEMENT

REMOVAL PROCEDURE
1. Remove the instrument cluster panel.




2. Remove the screws (2) that secure the radio to the support bracket (1).
3. Remove the radio from the support bracket enough to access the connectors at rear of the radio.
4. Disconnect the electrical/audio and antenna cable connectors from the radio.
5. Remove the radio.




6. If removing the radio mounting bracket. Perform the following steps:
1. Detach the clip retaining the HVAC harness to the radio mounting bracket.
2. Remove the screws (2) retaining the radio mounting bracket (1) to the instrument panel carrier.
3. Remove the radio mounting bracket from the vehicle.

INSTALLATION PROCEDURE




1. Install the radio mounting bracket. Perform the following steps:
1. Attach the HVAC harness to the radio mounting bracket with the clip.
2. Install the screws (2) in order to retain the radio mounting bracket (1) to the instrument panel carrier.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the screws to 3 N.m (27 lb in).




2. Connect the electrical/audio and antenna cable connectors to the radio.
3. Install the radio to the support bracket (1).
4. Align the radio locator tab into the support bracket locator hole.
5. Install the radio screws (2).

Tighten the screws to 2 N.m (18 lb in).

6. Install the instrument cluster panel.
7. Calibrate the new radio assembly. Refer to Service Programming System (SPS) in Programming. Programming and Relearning